The SubSurface Instruments Magnetic Locator ML-1, can be used to find iron and steel targets.
ML-1 is a non-metered device (audio only). This instrument is engineered to operate identically with the same controls as the ML-1M but without the visual meter.
Use this equipment to find:
- Corner markers (iron or steel)
- Mag nails and PK nails
- Valve and curb boxes
- Iron and steel pipes
- Well casings
- Manhole cover
- Steel drums and tanks
- Septic tank handles
- Energized electric cables
- Marker magnets
- Unexploded Ordnance (UXO)
- Illegal Taps (Iron or Steel)
||38.75 in (98.4 cm)
||2.0 lbs (0.9 kg) including batteries
||Two (2) standard 9-volt alkaline batteries
||40 hours minimum
|Easy and simple one-hand operation; built-in handle
|Easy to learn; 3 keypad switches: on/off and volume, sensitivity up and sensitivity down
|Volume built into the on/off key; just hold down the key while it cycles through the settings
|Electronic keypad that "clicks" when a key is depressed. A "real" speaker is in the front panel, providing outstanding volume.
|Microprocessor remembers the volume and gain settings from the last time the unit was on
|Non-metered (ML-1) and metered (ML-1M) versions are designed to look, feel and operate the same
|Strong aluminum monotube construction from the tip through the end of the handle and ABS injection-molded electronics case (3 ¼" tapered to 2 ½"-wide X 4 ½" tapered to 2 ½"-deep) provide the best structural integrity in a hand-held locator
|Lightweight; only about two pounds including batteries
|Uses 2 regular alkaline 9-volt batteries, parallel; the unit is shipped with two spare batteries
|Soft pack carrying case included (optional hard case available)
|Battery compartment separated from electronic components and circuit board. No exposing electronics to replace the batteries.
- Seven year manufacturer's limited warranty